Content Inside :
EXTENSION HOUSING OIL SEAL ON–VEHICLE REPAIR 1. REMOVE DRAIN PLUG AND DRAIN ATF 2. REMOVE FRONT EXHAUST PIPE AND HEAT INSULATOR (See page EM–94) 3. REMOVE PROPELLER SHAFT (See page PR–5). 4. REMOVE TRANSMISSION OUTPUT FLANGE (a) Using a chisel and hammer, loosen the staked part of the nut. HINT: Shift the shift lever to the P position. (b) Remove the nut. (c) Tap the output flange with a plastic hammer to remove it and 2 washers. (d) Using a screwdriver, remove the oil seal from the output flange. Remove extension housing Using SST, remove the oil seal. SST 09308–00010. Using SST and a hammer, drive in the oil seal with the lip facing downward. SST 09309–37010. VEHICLE SPEED SENSOR ON–VEHICLE REPAIR : Disconnect the No.1 vehicle speed sensor connector. (b) Remove the No.1 vehicle speed sensor assembly. (1) Remove the bolt the No.1 vehicle speed sensor assembly. (2) Remove the speedometer driven gear from the No.1 speed sensor. (3) Remove the O–ring from the No.1 vehicle speed sensor. (c) Install the No.1 vehicle speed sensor assembly. (1) Coat a new O–ring with ATF and install it to the No.1 vehicle speed sensor. (2) Install the speedometer driven gear to the No.1 vehicle speed sensor. (3) Install the No.1 vehicle speed sensor to the extension housing and torque the bolt. PARK/NEUTRAL POSITION (PNP) SWITCH ON–VEHICLE REPAIR : 3. REMOVE PARK/NEUTRAL POSITION SWITCH (a) Remove the control shaft lever. (b) Pry off the lock washer and remove the nut. (c) Remove the bolt and park/neutral position switch. 4. INSTALL PARK/NEUTRAL POSITION SWITCH (a) Install the park/neutral position switch and bolt. Torque: 13 N·m (130 kgf·cm, 9 ft·lbf) (b) Install a new lock plate and the nut. VALVE BODY ASSEMBLY ON–VEHICLE REPAIR NOTICE: When working with FIPG material, you must observe the followings. Using a razor blade and a gasket scraper, remove all old FIPG material from the gasket surfaces. Thoroughly clean all components to remove all loose material.
Tags : vehicle speed sensor, bolt park, bolt torque, heat insulator, razor blade, propeller shaft, toyota supra, driven gear, sensor assembly, position switch, oil seal, body assembly, neutral position, lock washer, valve body
If you see unrelated pdf files with the description or copyrighted material published, please report to us, we'll correct/delete it it as soon as possible.NONE OF THOSE MATERIALS ARE HOSTED IN THIS SERVER NOR UPLOADED BY ME IN SOMEONE'S SERVERS. Read our DISCLAIMER for more detail.
We are neither affiliated with authors and brands nor responsible for its content and change of content.
Information contained herein is provided "as is" without warranty of any kind, either expressed or implied, including any warranty of merchantability or fitness for a particular purpose. In no event shall ANYONE be held liable for any loss of profit, special, incidental, consequential, or other similar claims.