Part of Content :
In the Setup Menu •In the Input Sens menu, set the input sensitivity to correspond with expected audio source levels. •In the Speaker Config menu, select the crossover type as ILA 2way. •In the Sub Channel menu, select Enable or Disable corresponding to whether the system includes subwoofers. If the system includes subwoofers •In the Sub Management menu, configure the subwoofers as Stereo or Summed Mono. •In the Sub Gain menu, adjust the level to compensate for the use of more or fewer subwoofers than a typical system. •In the Sub Delay and Array Delay menus, you may add alignment delays if necessary. If the array is suspended below the subwoofer, the Sub Delay and Array Delay should be the same. If the array is suspended in front of the subwoofer, the Array Delay should be 12.0 ms greater than the Sub Delay setting. •In the Limiters menu, configure the output limiters to protect the loudspeakers or for clip limiting only of the SC28 output. Disabling the loudspeaker protection is not recommended.
Tags : loudspeaker system, source levels, management menu, input sensitivity, setup menu, 2way, typical system, audio source, channel menu, qsc, loudspeakers, crossover, alignment, subwoofer, array
If you see unrelated pdf files with the description or copyrighted material published, please report to us, we'll correct/delete it it as soon as possible.NONE OF THOSE MATERIALS ARE HOSTED IN THIS SERVER NOR UPLOADED BY ME IN SOMEONE'S SERVERS. Read our DISCLAIMER for more detail.
We are neither affiliated with authors and brands nor responsible for its content and change of content.
Information contained herein is provided "as is" without warranty of any kind, either expressed or implied, including any warranty of merchantability or fitness for a particular purpose. In no event shall ANYONE be held liable for any loss of profit, special, incidental, consequential, or other similar claims.