Part of content :
Part list : (NUT1) X 6 (WSH1) X 6 (BLT1) X 6 (GSK1) (Pre ’97 models only.) X 8 (BRK2) X 2 (GSK2) (Pre ’97 models only.). Installation instruction : Please read all of your directions and cross check your parts list before starting installation. Refer to you owner’s manual and follow instructions to remove your soft top. Place the back section of the hardtop on the vehicle and align the pre-drilled holes in the hardtop flange on both sides of the hardtop with the #1, #2, and #3 holes on the rails of the Jeep. Install the brackets (part BRK2) to the windshield frame, just below the existing holes where the soft tops was attached. PRE-97 Jeep ONLY Run the gasket (GSK1) along the top of the windshield. Position the hardtop with doors in shut position so that the gap between the hardtop and
doors just barely clear hitting each other. You may have to push on the rear of the hardtop forward to adjust the fit! (Refer to Upper Door Installation Sheet if you have the upper half doors to install with your top).
Tags : windshield frame, jeep wrangler, half doors, soft tops, flange, gasket, gap, brackets, jeep, holes, models
If you see unrelated pdf files with the description or copyrighted material published, please report to us, we'll correct/delete it it as soon as possible.NONE OF THOSE MATERIALS ARE HOSTED IN THIS SERVER NOR UPLOADED BY ME IN SOMEONE'S SERVERS. Read our DISCLAIMER for more detail.
We are neither affiliated with authors and brands nor responsible for its content and change of content.
Information contained herein is provided "as is" without warranty of any kind, either expressed or implied, including any warranty of merchantability or fitness for a particular purpose. In no event shall ANYONE be held liable for any loss of profit, special, incidental, consequential, or other similar claims.