Removal Romoval guide : 1) Raise vehicle and support with safety stands. Disconnect battery tube. Remove shift rod from right side of transmission case. Remove bolts and nuts attaching exhaust pipe and catalytic converter. 2) Remove solenoid and inhibitor switch connector. Remove speedometer cable. Remove drive shaft. Fit main shaft holder (49 0259 440) into main shaft in transmission case to prevent oil leak. Remove starter and gusset plates. INSTALLATION Reverse removal procedure to install transmission, noting
the following: When installing torque converter, be sure that notch in converter lines up with notch in oil pump. TRANSMISSION SERVICING : Inspect automatic transmission fluid level every 7,500 miles or 8 months. FLUID LEVEL 1) Check fluid with vehicle on level floor. Apply parking brake firmly and run engine approximately 2 minutes at 1200 RPM. 2) With engine running at normal idle, move selector lever through all gears, pausing at each gear to allow for engagement. 3) Return to “P” position and leave engine running. Wipe area clean around dipstick filler tube and remove dipstick.
Tags : automatic transmission fluid, mazda rx7, bolts and nuts, speedometer cable, inhibitor switch, drive shaft, torque converter, filler tube, shift rod, transmission case, exhaust pipe, oil leak, catalytic converter, oil pump, solenoid
If you see unrelated pdf files with the description or copyrighted material published, please report to us, we'll correct/delete it it as soon as possible.NONE OF THOSE MATERIALS ARE HOSTED IN THIS SERVER NOR UPLOADED BY ME IN SOMEONE'S SERVERS. Read our DISCLAIMER for more detail.
We are neither affiliated with authors and brands nor responsible for its content and change of content.
Information contained herein is provided "as is" without warranty of any kind, either expressed or implied, including any warranty of merchantability or fitness for a particular purpose. In no event shall ANYONE be held liable for any loss of profit, special, incidental, consequential, or other similar claims.