This manual contain information about installing the Auxiliary LED brake for the Harley Davidson motor. If this manual states that this product may be mounted with suction cups, magnets, tape or Velcro™, clean the mounting surface with a 50/50 mix of propylene alcohol and water and dry thoroughly. It is recommended that these instructions be stored in a safe place and referred to when performing maintenance and/or re installation of this product. If you are mounting the light head on a Harley Davidson motor cycle box, use the existing wire hole. Drill your mounting holes so the wire hole (located very close to the mounting hole in the light head) will line up with the wires, but not interfere with the mounting holes. Mark the location of the 2 mounting holes onto the mounting surface using the dimensions shown above, or remove the lens and use it as a template. Always check behind the mounting surface to be sure you will not interfere with any other vehicle components. 2. Drill the 2 mounting holes using a drill sized for a #6 sheet metal screw, then drill the 9/32” wire access hole 5/16” away from the mounting hole as shown.
Tags : sheet metal screw, harley davidson motor, led brake, harley davidson, manual states, vehicle components, suction cups, motor cycle, propylene, safe place, velcro, holes, magnets, alcohol
If you see unrelated pdf files with the description or copyrighted material published, please report to us, we'll correct/delete it it as soon as possible.NONE OF THOSE MATERIALS ARE HOSTED IN THIS SERVER NOR UPLOADED BY ME IN SOMEONE'S SERVERS. Read our DISCLAIMER for more detail.
We are neither affiliated with authors and brands nor responsible for its content and change of content.
Information contained herein is provided "as is" without warranty of any kind, either expressed or implied, including any warranty of merchantability or fitness for a particular purpose. In no event shall ANYONE be held liable for any loss of profit, special, incidental, consequential, or other similar claims.