Content inside :
3 Mount the brake magnet using the 4 holes or slots in the mounting flange. Concentricity between the brake mounting pilot diameter and the shaft should be held to .010 inch T.I.R. The FB17 and larger have an inside pilot diameter as well as an outside pilot diameter. The brake flange should be bolted tightly to the bulkhead as it is the reaction member for the brake torque, PRE-ASSEMBLY INSPECTION. STEP 1 All parts should be examined for any damage during the shipping and handling process. Measurements should be taken to ensure parts meet mounting
requirements. All parts must be clean and free of any foreign material before attempting assembly. Prior to installing the FB brake, ensure that the shaft is square with mounting plate so that the armature to magnet air gap may be properly set. INSTALLATION OF KEY STEP 2 Install key in shaft. Key should fit keyseat with a tight fit on the sides and slight clearance over the key. Recommended Tightening Torques charts.
Tags : fb series, air gap, assembly inspection, concentricity, manual content, tight fit, armature, bulkhead, flange, shipping and handling, shaft, gap, magnet, diameter, brakes
If you see unrelated pdf files with the description or copyrighted material published, please report to us, we'll correct/delete it it as soon as possible.NONE OF THOSE MATERIALS ARE HOSTED IN THIS SERVER NOR UPLOADED BY ME IN SOMEONE'S SERVERS. Read our DISCLAIMER for more detail.
We are neither affiliated with authors and brands nor responsible for its content and change of content.
Information contained herein is provided "as is" without warranty of any kind, either expressed or implied, including any warranty of merchantability or fitness for a particular purpose. In no event shall ANYONE be held liable for any loss of profit, special, incidental, consequential, or other similar claims.