Content Inside :
Materials/ Tools required for this installation: 1. #2 Phillips screwdriver 2. Powered screwdriver or drill with adapter
3. Razor knife or similar 4. 1/4″ hex socket bit 5. Awl or similar tool 6. 5/16″ hex socket bit 7. Audiovox Series 640/650 Video Module PREPARATION OF VEHICLE INTERIOR, 1. Remove and discard front mounting screw from
overhead console and pull downward to release clips at rear of console. See Figure 1. Install and route all accessory wiring, video and audio cables, and any other added component requirements to their respective places in the vehicle. Refer to component installation instructions for wiring diagrams. Using the diagram in Figure 6, construct a jumper harness that will connect the vehicle’s dome light wire harness to the new dome lights in video system. Make sure that lights in video system operate from the door jamb switch.
Tags : phillips screwdriver, hex socket, dodge durango, razor knife, audio cables, added component, component requirements, video module, component installation, vehicle interior, dome light, wire harness, wiring diagrams, awl, video system
If you see unrelated pdf files with the description or copyrighted material published, please report to us, we'll correct/delete it it as soon as possible.NONE OF THOSE MATERIALS ARE HOSTED IN THIS SERVER NOR UPLOADED BY ME IN SOMEONE'S SERVERS. Read our DISCLAIMER for more detail.
We are neither affiliated with authors and brands nor responsible for its content and change of content.
Information contained herein is provided "as is" without warranty of any kind, either expressed or implied, including any warranty of merchantability or fitness for a particular purpose. In no event shall ANYONE be held liable for any loss of profit, special, incidental, consequential, or other similar claims.