Content Inside :
INSTALLING THE RADIO GEAR, Properly plug the connectors/wires into the receiver: steering servo connector/wire into channel 1 slot, throttle servo connector/wire into channel 2 slot, and battery switch connector/wire into battery slot. INSTALLING STEERING SERVO LINKAGE, nstall the threaded part of the linkage rod into the plastic tie-end. The linkage rod with tie-end should measure 70mm when finished. OPERATING RADIO STEERING FUNCTION, ADJUSTING CARBURETOR, To set the high speed needle (large needle sticking out from the carburetor body), turn the screw as pictured. Initial high speed needle setting should be 2.5 turns (close the needle completely, then back out 2.5 turns). Clockwise turn will provide leaner setting (lower fuel to air mixture), and counterclockwise turn will provide richer setting (higher fuel to air mixture). Please refer to ENGINE BREAK-IN/SETTING procedures to properly set the engine. a. Build the throttle/brake linkages as shown on the diagram. b. Secure the brake cam lever onto brake cam with set screw. c. Install the servo horn onto throttle sero output shaft.
source : www.roundabouttoys.com
Tags : air mixture, carburetor body, output shaft, set screw, speed needle, plastic tie, monster truck, radio gear, battery switch, manual content, channel 1, servo, linkage, linkages, high speed
If you see unrelated pdf files with the description or copyrighted material published, please report to us, we'll correct/delete it it as soon as possible.NONE OF THOSE MATERIALS ARE HOSTED IN THIS SERVER NOR UPLOADED BY ME IN SOMEONE'S SERVERS. Read our DISCLAIMER for more detail.
We are neither affiliated with authors and brands nor responsible for its content and change of content.
Information contained herein is provided "as is" without warranty of any kind, either expressed or implied, including any warranty of merchantability or fitness for a particular purpose. In no event shall ANYONE be held liable for any loss of profit, special, incidental, consequential, or other similar claims.